Home > AC EMI Filter > Single Phase Filter > AC Single Phase Power Line Noise Suppression Filters

AC Single Phase Power Line Noise Suppression Filters

Payment Type:	T/T
Incoterm:	FOB,CFR,CIF,EXW
Min. Order:	2 Piece/Pieces
Delivery Time:	7 Days

Contact Now

Basic Info

Model No.: FT110/FT111

Rated Voltage: 110/250VAC

Operating Frequency: 50/60Hz

Rated Current: 0.5~300A@40℃

Test Voltage: 1760VDC, 3S(line-line); 2000VAC, 3S(line-ground)

Climatic Category(IEC 60068-1): 25/085/21(-25℃ /+85℃ Damp Heat Test For 21 Days)

Additional Info

Packaging: Carton

Productivity: 500,000pcs annually

Brand: FILTEMC

Transportation: Ocean,Air

Place of Origin: Jinan

Certificate: ISO9001, CE, UL, TUV, RoHS

HS Code: 8548900001

Port: Qingdao,Tianjin,Beijing

Product Description

Power line filters made by FILTEMC, which are widely applied for various fields.

The features and benefits of the noise suppression filters:

General purpose AC RFI filters with good attenuation performance at frequency range 150KHz~30MHz.

Compact structure, high performance-cost ratio, easy to install, safe and reliable.

FT110 and FT111 series are one-stage common mode filters with almost the same filtering effect, only slight difference according to different current.

High voltage versions above 380VAC are also available.

Typical applications of noise suppression filters:

Electrical & electronic equipment
Consumer goods
Household appliance
Medical device
Office automation equipment
Datacom equipment

1. Storage of EMI Filters: The RFI filters mustn't be left out in the heat of the sun or exposed to the rain, it should be stored in warehouse with good ventilation, surrounding temperature between -30℃ and +65℃ , the highest relative air humidity lower than 90%, and no corrosive liquid or gas.

2. Installation of EMI Filters:

Power line filters should be installed at power input, and the line inside the chassis be as short as possible to reduce radiated interference.

Both input and output lines of EMI filters neither be intersected nor be tied up by string.

Make sure the mounting flange fully grounded, and keep the ground cable as short as possible if filters are connected to other equipment.

If the terminal is stud, please use two spanners to fasten the screw nut when connecting to avoid stud rotating and thus causing changes to the internal circuit and consequently leading to filters arcing, short circuit, broken down or the filtering effect worsened.

First use spanner1 to fix the screw nut near the metal case, then use spanner2 to tighten the screw nut in front( shown as Figure1), otherwise the terminals may be damaged.

Apply the same for the connection of other phases.